CE qualificationCE is the abbreviation for Conformité Européenne (European Conformity). Products are identified with CE when they correspond with the coordinated European product standards.
Cleaning of glassAs part of the facade, glass is subject to natural and building-related soiling. Normal dirt, professionally cleaned at reasonable intervals, presents no problem to glass.
European standardsThe most important norms for the assessment and the use of glass in connection with buildings
Glass edgesThe quality of glass edges of single panes that are built into a glass system has an enormous influence on the longevity of the product. Glass edges without further processing may show micro-cracks, which have negative effects and can lead, in extreme cases, to breakages.
Glass thickness dimensioningThe installed glass is subject to different loads and should therefore be dimensioned according to the conditions. In addition to positive/negative wind and snow loads, its own weight and when using insulating glass, the climatic loads in the cavity should also be considered.
Guidelines for assessing the visual quality of glass in buildingsThe appearance of coated glass and defect detection is described in the EN 1096-1 standard. The defects affecting appearance are specific to the glass substrate (e.g. float glass acc. to EN 572-2) or specific to the coating. If a defect specific to the glass substrate is more visible because of the coating, it will be treated as a coating defect.
Material compatibilityAs a building material, glass comes into direct or indirect contact with a number of other materials such as PVB films, insulating glass edge seal, setting blocks, press sealing of pressure glazing or sealing mass and elements at joint gaps and glass corners.
Tolerances for standardised requirementsThe basic principles for tolerances are specified in the applicable standards. However, these standards are not always sufficient in actual practice. This chapter therefore describes those applications that are listed in the standards where they are not clearly defined or are not specified at all.
Transportation and storageGlass should generally be transported standing on its edge. This edge generally stands parallel on two cushioned supports.
CE is the abbreviation for Conformité Européenne (European Conformity). Products are identified with CE when they correspond with the coordinated European product standards.
CE is the abbreviation for Conformité Européenne (European Conformity). Products are identified with CE when they correspond with the coordinated European product standards. It is neither an emblem of origin nor a quality symbol but rather declares that a particular product complies with the „Regulation (EU) No 305/2011 of the European Parliament and of the Council of 9 March 2011 laying down harmonised conditions for the marketing of construction products and repealing Council Directive 89/106/EEC”. This regulation confirms that the product can be marketed in all EU countries without any reservations. National special requests, however, may define additional specifications for use of these products. With the CE identification, the manufacturer declares that the product complies with the underlying product standards.
Proof of this compliance is made on very different levels, two of which are relevant for glass:
- Level 1: Type test by a notified body institute with internal production control and external monitoring
- Level 3: Declaration of performance (DoP) of the manufacturer after type test by a notified body institute with internal production control
The requirements are defined in the following product standards:
The introduction of these rules has replaced the national standards. These EN standards have common characteristics such as:
- Quality management system
- Definition of quality characteristics
- Definition of quality checks